Alarm mode:

Once the tag is close to the antenna for about one meter, the message is sent to the alarm host, and the high-decibel alarm on the host site is shocked, so that our staff will lock the target for interception.

Security method for the security door:

Be sure to use a separate loop power supply with a ground wire. Do not use a plug-in board with other appliances.

The anti-theft door should be installed with a pre-embedded conduit (empty conduit), or there should be no AC 220V power cord under the floor. The AC220V power socket is installed more than 80 cm away from the security door.

installation steps:

1. Confirm that it is working properly: Connect the security door at the location to be installed, test the effect and whether there is a false alarm. Can be installed after the test is normal

2. What should I do if I encounter environmental disturbances: 1 computer debugging change settings 2 contact us online help 3 remote control debugging

3. Fixed installation: After installation, confirm that the connecting cable is fixed with expansion screws or covered with floor tiles. Note: It is best to complete the installation by professional installers.

4. Installation complete the final test: whether the test is functioning properly and the effect is as good as interference or poor effect. You can use the computer to debug or contact our engineers for one-on-one assistance and remote control debugging.

Installation note:

1. Do not install the security door on the wall, 15 cm away from the wall.

2. The security door must be tested for several hours before installation without any problem.

3. Hanging clothes need to be more than 1 meter away from the security door, and the shelf needs to be more than 1 meter away from the security door.

4. The intermediate cable is covered with a wire slot or placed under the floor tile